Search the Community
Showing results for tags 'Dowgrade'.
Hello and welcome! Today I will be showing you all how to downgrade your Nintendo Switch Firmware on your exploitable Switch! Please see the video below for a visual instructional TUT, or see steps i have written out below the video! So to complete this tutorial you will need the following: - Switch Vulnerable to the tegra exploit - A way to enter RCM mode and launch hekate boot loader - You will need ChoiDujourNX which you can get here - https://switchtools.sshnuke.net/ - The desired firmware to downgrade to (you will need to locate this one on your own... Google is your best friend ) Step 1: Make sure you meet the above requirements. Step 2: Copy the ChoiDujourNX.nro into the following directory on your Switch SD card "/switch/ChoiDujourNX.nro" Step 3: Copy the firmware folder to the root of your usb. It should look something like this "/firmware 3.0.0" Step 4: Safely eject SD card, and insert into Switch. Step 5: Boot into hekate and then into your CFW. Step 6: Open the homebrew Menu, and launch ChoiDujourNX. Step 7: Open the folder with the firmware you copied to the SD card, in my case, it would be "firmware 3.0.0" Step 8: Press the select button down the bottom right. Step 9: wait for it to load, and select which version you want to use, i would suggest using (exfat) as it supports both fat32 and exfat, you can do as you wish! Step 10: After the checks are complete, you can proceed by pressing "Select firmware" again. Step 11: Wait for the firmware to be extracted and prepared, to the left you will see a menu, unless you are using a specific exploit where you do NOT want the switch to have auto RCM, or if your switch has been patched, i suggest keeping this selected at all times! This will prevent you from accidentally burning fuses and will just make your life easier when booting! Step 12: Confirm the target firmware is correct, and i would not select system initialize unless again, you need to for some special reason. Step 13: When it is all extracted, press "Start installation" and wait a few min for the process to complete. Step 14: When step 13 is complete, you can press "Reboot" and then followed by "Reboot now" to be rebooted back to the payload "hekate" Step 15: Boot into your cfw (i use SYSNAND, maybe you use EMUNAND? Just boot as you normally would) Step 16: Check firmware version in settings. Step 17: Profit? If you have any further questions or issues, please feel free to drop me a line and i'll be more than happy to guide you a bit further! Peace and catch you next time!